Interested to Buy Any Domain ? << Click Here >> for more details...
what is full form of SMART
- 46 Answers
- 90957 Views
- Infosys, ITC Infotech, Lanco, Rosemount, Solvay, I also Faced
- E-Mail Answers
Answer Posted / santosh marale
Specific Measurable Achievable Relevent testable
| Is This Answer Correct ? | 76 Yes | 61 No |
Post New Answer View All Answers
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is the responsibility of an instrument commissioning supervisor
is motorized valve closed when power shutoff?
Explain working principle of lvdt?
What is the start up procedure of desalter
How to Calibrate Level Troll in field
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
please send data bank of quetions answers on analytical instrumentation.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is difference between fork type and capacitance type level switch. where it is using
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
