WHAT AC (HI VOLTAGE TEST) VOLTAGE SHOULD APPLY FOR 33KV
CABLES.EXPLAIN IN DETAIL
- 12 Answers
- 19028 Views
- NTPC, Voltech, I also Faced
- E-Mail Answers
Answer Posted / s bhattacharya
TO DECIDE THE VOLTAGE APPLICABLE FIRST THING TO SPECIFY
TYPE OF CABLE .
1.IF SINGLE CORE 9NEW CABLE)THEN AS PER IEC GO FOR
BILX0.8/1.732 -AC WITH VARIABLE FREQUENCY CONTROL KIT TO
ADJUST THE FREQUENCY AS PER CABLE LENGTH.
FOR CABLES LESS THAN 132kV.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
What the difference between ac and dc inductor an capacitor
Dry type transformers
which types of relay used in acb and vcb?
The shot circuit in any winding of transformer result? Explain
what is negative and zero impedance in 3 phase induction motor ??
define the non synchoronism of synchoronous machine in general g or m??
How is the speed of a DC shunt motor related to the armature current?
what is earth resistance? how to measured? and give values at power station and mcc area?
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
Grid fault level [KA]?
How to calculate VCB rating for 33KV ,25 MW Power line?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
What test must you do before powering up a circuit that you have been working on?
