Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sukhvinder
Transfrmer has
1. routine tests
2. type test
3. special test
further type tests are
1. IR OF WINDINGS
2. POLARITY
3. VOL. RATIO
4. TEMP RISE TEST
5 DIELECTRIC LOSS
| Is This Answer Correct ? | 21 Yes | 5 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
How to improve fuel cell in a distribution system?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
howmany electrician should maintain for a 1000 kva used plant... in kerala..
checking procedure of capacitor based motors.used in fans etc?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
mccb service sittings be done?
what is negative and zero impedance in 3 phase induction motor ??
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
What is the difference between security constraint unit commitment and security constraint optimal power flow?
