why we used to transmitt the power at higher voltage why
not at lower voltage
Answer Posted / ram
power losses inversly prop to square of voltage
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
700KW 6.6KV slip ring induction motor to use VFD to control the speed
What is difference between mcb and mccb.
What difference between ref protection and differential protection ?
What is the universal motor?
what is circuit recombiner and how it is different from circuit breaker
How does zener phenomenon differ from avalanche breakdown?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
What is difference between safe PLC and normal PLC
What is the cut-off rate?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?