Interested to Buy Any Domain ? << Click Here >> for more details...
Suppose am having the PF value .8, so how can we say that
is it lagging or leading?
- 11 Answers
- 15930 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / mukund
if you are considering any equipment such as motor or
lighting load such as fluorescent lights
most of the loads are inductive in nature
you are talking about 0.8 lagging p.f.
people are using capacitor banks to improve p.f. upto unity
in this case it is definately 0.8 lagging p.f.
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
Explain the operation carried out in thermal power stations?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
why the voltage and current in a long transmission line are called travelling wave?
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
How much load can be taken for chiller from 1500 kva transformer
what is the use of expulsition protective gap in 11Kv line.
What is a copper loss or i2r loss pc?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What is the difference between AC and DC injection methods for rotor earth fault protection
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
Star Delta Diagram with full description
Why AC current leads voltage in capacitor and how?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What is the breaking capacity of transformer and how can we calculate the breaking capacity of tranformer
