Interested to Buy Any Domain ? << Click Here >> for more details...
What is LT? And specify the range of voltage?
- 10 Answers
- 25044 Views
- HSL, I also Faced
- E-Mail Answers
Answer Posted / veresh g
# 1 LT is low tension side,and the specify range is 415v
| Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
how to deside the capacity of chock for drive?
what is a bus riser in power system and why it is used
What is EMC filter in VVVF Drive ?
What is the universal motor?
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
How much load can be taken for chiller from 1500 kva transformer
why -48 volts dc used in telecommucation
what is the function of anti pumping relays? what is KVAR? How it is generated in alternator? What is 3rd Harmonics? What is IDMT relay?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
why is using sensor?what is differece between photoelectric and proxmitty?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
