CONSIDER A 415V/200V STEP DOWN TRANSFORMER.CAN WE USE USE
IT AS STEP UP TRANSFORMER BY GIVING 200V IN SECONDARY AND
TAKING OUTPUT FROM PRIMARY?
- 22 Answers
- 23856 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / kanth
i agree with 9 th answer
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
11 kV line deraction check by an Engineer.
How much ph is maintained of water resistance starter for slipring induction motor ?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What are the conditions to be satisfied for parallel operation of dc generators?
What is inrush current?
what are the difference between PLC and embedded
how to calculate fault level?
How to select HT/MV cable size ?
What is the slip speed?
Why can't we parallel Voltage transformer secondary circuits?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
