What is the usega of brking resistor? and how it will
useful to Drive...?
- 3 Answers
- 4412 Views
- I also Faced
- E-Mail Answers
Answer Posted / shinyvikram ganji
usually braking resistor is associated with drives.suppose
a motor is running at some speed.assume the supply is cut
of suddenely.but the rotor continues to rotate and
generates emf.so the produced emf is to be dissipated in
the resitor for motor to be halted
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Is it possible to measure the voltage of a battery from a single terminal?
Why HT 11 KV Slipring Motors are connected in star ?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
how we calculate the short circuit capacity of the busbar in LV & HT?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
Why generation voltage in thermal power plant is between 11kv to 33kv?
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
Why efficiency of generator is higher than motor at a particular load?
