Answer Posted / reshi

ELECTROMAGNETIC RELAYS WORKS UNDER THE PRINCIPLE OF
ELECTROMOTIVE FORCE.IT USES MAGNETIC CORE AND PLUNGER FOR
THE SENSING AND ACTIVATION OF THE CIRCUIT.
WHERE AS STATIC RELAY COMPRISES OF ELECTRONOC CIRCITARY AND
USES LOGIC FOR THE SENSING AND ACTIVATION OF THE CIRCUIT.
ADVANTAGES-STSTIC RELAYS ARE LIGHT WEIGHT , RELIABLE AND
THE RESPONSE IS FASTER THAN THE ELECTROMAGNEIC RELAYS.

how to calculate power consumption in slip ring motor at different step

2244

---

Can we use Ccapacitive voltage transformer directly for metering purpose?

1868

---

if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?

2038

---

wht is embedded systems? what is new inthis field?

2011

---

What types of high speed CMOS circuits have you designed?

2141

---

I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.

1877

---

Pl. share your experience about industrial-electronics repair of machine tool.

1906

---

how to calculate the fault in substation

2462

---

What is the function of NER and NET?

2453

---

What is gain margin?

1090

---

Differentiate between low pass, high pass and band pass filter?

1075

---

what is the voltage between earth to neutral in lift.

1833

---

orifice sizing how done, checking & selection

1968

---

Define steady state error.

1104

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

2042

---