Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the size of cable for 100 kva load,?can
somebody tell me with a formula
- 7 Answers
- 28074 Views
- Apollo, I also Faced
- E-Mail Answers
Answer Posted / abdulsubur
WE CAN GET FROM THIS REALTION
KVA=KW/KVAR
100*85=85KW
THEN FIND CURRNET FROM P=ROOT 3 VICOSPHI FORMULA THEN FIND
CURRENT AND THEN LENTH FROM THE MV=VD*1000/L*I
| Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
how we can calcultae the short circuit level for bus bar
what is meant by impedance & transient protection?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
full form of flry b
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
What is Traction? 1KVA Alternator, How much urrent taken?
Define what is the function of anti-pumping in circuit breaker?
show the single line diagram of star delta starter with single phase preventer
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
What are the three constants associated with a steady state error?
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
What is maximum power transfer theorem?
What descriptive information does the NEC require to be marked on all conductors?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
