for 12KW motor which cable size has to select for ex.10
meter.
- 4 Answers
- 14099 Views
- I also Faced
- E-Mail Answers
Answer Posted / abdulsubur
FROM THE FORMULA P=ROOT3 VICOS PHI
12/ROOT3*400*.85 WE GET I=20
VD= MV*L*I/1000
WE GET 10 SQR MM+EARTH CABLE 6 SQR MM
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
why in the three pin plug all 3 pins are cutted ?
Classify drilling machines.
What is knee point voltage of transformer?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
substation+ plc system
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
why 1.7Uo for HV cable Hi pot test?IE standard why?
what about electrical pannel.? What is meant by plc pannel.?
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
When is lag lead compensator is required?
What is boucholz relay and the significance of it in to the trformer?
Why Neutral Isolation is required?
