Why Clock rate command is not configured on ethernet
interface of a router?
- 6 Answers
- 13549 Views
- I also Faced
- E-Mail Answers
Answer Posted / b
clock rate command always applied on the Serial interface
bcoz it is used for syncronization at DCE end not DTE.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is ccna?
Name the command we use for ping in ipv6?
What is the igp (interior gateway protocol)?
How many ways are there to implement VPN architecture?
Explain the term 'unicast'.
When we use extended access-list?
What are the advantages of a layered model in the networking industry?
Explain the difference between bus topology and hub?
How do you depict an IP address?
What are 10base5 ethernet lans?
What are the different types of cables that are used in routing?
Why is vlan used?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
how we update the IOS version with the help of TFTP?
What are 10base2 ethernet lans?
