Transformer's core is made up of which material and why so?
- 10 Answers
- 29172 Views
- ABB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / monalisa rout
softiron because it reduces eddy current loss
| Is This Answer Correct ? | 5 Yes | 10 No |
Post New Answer View All Answers
are there rmu for 3 transformer?
What is different between Circuit breaker and Isolater?
what type of questions are asked and howmwny questions belong this catagory?
What id difference between power and energy?
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
How is the connection of the tap changer on the HV side been made?
why are the maintaine power factor and how can this control and this is how work.
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
How it can worked plc based electrical system And which type of software using.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
