Interested to Buy Any Domain ? << Click Here >> for more details...
In an LT pole, the line voltage is 415V. How is it
converted to 230V into the house via the service cable?
- 10 Answers
- 18479 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandrashekar g
Actually there will be 4 wires ie 3ph 4wire system
for 230v supply can be achieved by taking one phase and one
neutral from it.
| Is This Answer Correct ? | 31 Yes | 0 No |
Post New Answer View All Answers
What safety precaution are to be taken for avoiding electric hazards ?
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
my diploma certificate in my higher education college
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
Why collecting electrode of ESP to be earthed
how to determine motor size for a fan application?
Is MEN and RCD related to each other ?? IF yes then how??
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
what is effect of leading power facter on the system and billing
What are the different losses In a de mac1une'! t.xplam
What happen Grid EARTH plat got cut.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
how unidirectional torque is produced in DC motor?
