If load is 240 kw & pf is 0.8 lagging, than how to increase
it from0.8 to 1.0(unit),which rating capacitor used, please
give me Calculation. What is effact of consumer & suplier
if pf is lagging or leading with on effect machines/ TF/GE
etc.
- 6 Answers
- 10674 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / abduljameel
Normally required capacitors will be in KVAR.
Required KVAR = KW (tan pi1 - tan pi2 )
cos pi1= .8
cos pi2 =1
then calculate accordingly
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what is the transformer turn ratio formula and give some examples?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
what is your aim
How does an oscillator differ from an amplifier?
What is the voltage gain or transfer function of amplifier?
what type of motor used to move a 1 ton gate? and relate ratings with load.
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
State kirchoff voltage law?
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
what are the installation procedure of high voltage power transformer,CT,CB&PT?
What is time response of the control system?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
why we use circuit breakers for switching instead of normal switching device?
