why does a transmitter o/o signal starts from 3-15psi or 4-
20mA?
- 11 Answers
- 16259 Views
- I also Faced
- E-Mail Answers
Answer Posted / priyabeet das
1st of all this is a live zero concept. now what is live zero? suppose the range is 0-20ma.so the Tx will indicate0ma as lower value.but when there is no i/p or there is some fault in process then also Tx will show 0ma as reading. so , seeing 0ma we cant decide whether it is for any i/p or not. that is why the lower LRV is chosen as 4ma.
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
What is the use of temperature compensation?
what is the process to make control schematic ?
Make Heater Process Logic.
What is the difference between working pressure and calibration pressure of a control valve
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
How does your previous experience relate to the job you are applying for ?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
