Answer Posted / akshay deep tripathi
25 mva is the primary windig voltage and 41 mva is the
seconry winding voltagr of a transfarmer
| Is This Answer Correct ? | 3 Yes | 47 No |
Post New Answer View All Answers
what is the function of gss in the dg set.
what are the analog quality input for protection function?what are minimum reqiments?
what parameters are should nessary for control technic dc drive(in rolling mills)?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
how to meas-our losses for L.T & H.T
Why is better to have a minimum ceiling voltage of 250% than 160%?
bus bar design conditions and sizing pls tell me quickly
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
What is the feedback in the control system?
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
How npn and pnp transistor works
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
