Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if the secondary of current transformer
kept open....
- 16 Answers
- 35249 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / r. k.d
Whatever Rajkumar said is totally correct. I like to add
few points in it. when CT is open from secondary side than
it can be assumed that CT secondary resistance is infinite.
Hence, CT will try to increase mag. flex in the core and
when it will cross its rated burden it will get heated and
may explode.
Please remeber that CT will not blow if passes low current.
CT will blow in high current passed for long time only.
that s why CT get blast when short circuit current flows
from the CT.
As open secondary offers high resistance, so it will
produce high voltage accross it.
Hope its clrear.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
How to assume answer to electrical questions
What is meant by stator?
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
Write down the brushes of a de machine.
which of the following elements is not present in stainless steel
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
Why armature rheostat is kept in maximum position?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
will there be any problem by recovering slip from single phase induction motors?
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
How you calculate the repturing capacity of a HRC fuse
please explain how to do 'pole drop test' on generator?
which protection used in power plant?
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
