Interested to Buy Any Domain ? << Click Here >> for more details...
what we happen if 400 kvar cpacitor banks are on in manual
mode and there is no load on mains ??????????????
- 7 Answers
- 11106 Views
- HCL, Reliance, I also Faced
- E-Mail Answers
Answer Posted / rahul shukla
VOLTAGE WILLL RISE AND ALL LOADS i.e motors ect. get
overfluxed as v/f ratio will be high
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
give me applications of sequence bridges . (used in 3 phase un balanced systems)
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
how the inner and outer body is separated in aircrafts?
How is magnetic leakage reduced?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What happen in ups if phase reverse?
why asa method ZPF method is more accurate than ASA method?
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
What descriptive information does the NEC require to be marked on all conductors?
how we decide the require size is this for a known current at fuu load?
why we use copper earthing for neutral while for body GI.
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
