Interested to Buy Any Domain ? << Click Here >> for more details...
1. how much normal earth resistance in earth pits(neutral
and body earth) and transformer neutral and body earth &
panel earth.
- 12 Answers
- 100582 Views
- HP, Malladi Drugs and Pharmaceuticals, Pearl Engineering, PL, I also Faced
- E-Mail Answers
Answer Posted / shri6181
even any earth pit is concidered every earth pit should have the value 0ohms.but in rare cases u will get that value,more over will come 0.3to 0.9,there fore the earth pit value should be less than 1 ohm.ok
| Is This Answer Correct ? | 68 Yes | 9 No |
Post New Answer View All Answers
what is the concept of directional power?
why constant voltage transformer should be start without load? and if started then what will happen?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
solar energy light efficiency & disadvantages?
what is a vector protection in transformer
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
how does a liquid starter reduce the starting currents?
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
Graphs of measuring power and speed on dc motor
What is meant by reset level of the relay?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
how rectifier transformer work in electroststic precipetatore(esp?
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
