Interested to Buy Any Domain ? << Click Here >> for more details...
What is the current flow in 230v ac supply ?
What is the current flow in 415v Ac supply ?
- 6 Answers
- 32187 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhishek0015
It depends upon connected load. As per formula,
P= V*I*(cos phi)-- for 230v supply and
P= sqrt3*V*I*(cosphi)-- for 415v supply
So it means in 230v single phase supply takes almost 3
times more current than 415v three phase supply.
| Is This Answer Correct ? | 26 Yes | 4 No |
Post New Answer View All Answers
explanation of mesh bus bars
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
Whether amorphous core transformer is commercialized or not:Name of company making amorphous core transformer and what are different rating?
sir pls send the je exam - 2008 and other model question papers..
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
pls,send the previous year written test questions.
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What is the cut-off rate?
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
how to modify DOL control panel into Delta Y connection?
