Interested to Buy Any Domain ? << Click Here >> for more details...
What is the thumb rule for calculating the P.F correction
Capacitor?? Say for 100 hp motor how much micro farad
Capacitor is needed .... Thumb rule so quick answer wanted
- 9 Answers
- 24930 Views
- Bhel, Dubai Group, I also Faced
- E-Mail Answers
Answer Posted / himanshu
Motor is an inductive load so it is consuming
active power that depends on its load and
reactive power that is consumed by motor to set up its
magnetic field it is constant so we should connect a
capacitor which consumes the negative reactive power
according to p.f. correction requirement.
| Is This Answer Correct ? | 5 Yes | 10 No |
Post New Answer View All Answers
Where voltage are high and current to be interrupted is low the breaker preferred is:
how the B-H loop obtain under the static condition
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
should %impedance be high or low in a power transformer? if so why?
What is a copper loss or i2r loss pc?
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
How i can calculate current of cable according to ares?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
What is control system?
What is critical disruptive voltage?
How out of step protection relay works?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
When and where resistance earthing is used ? How to calculate the time constant for earth fault
