Interested to Buy Any Domain ? << Click Here >> for more details...
How many earthings are required for commissioning the
Transformer?
- 14 Answers
- 35614 Views
- Dalmia Group, HSL, I also Faced
- E-Mail Answers
Answer Posted / ganesan.n
Generally three earthings will be provided near the
transformer, they are namely:
1. Earthing for Lightining
arrester located at the pole structure,
2. Neutral Earthing,
3. Body Earthing
| Is This Answer Correct ? | 53 Yes | 9 No |
Post New Answer View All Answers
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
what are the different methods for the starting of a synchronous motor.
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
What are the advantages and disadvantages of the ac motors?
size of condotory fron voltage level
Earth bits close or open. Which is correct
Why is the starting current high in dc motor?
how withstand of hi-pot test outputs of transformer wire 2.5mm
What is a dominant pole?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
nwhat are the main Components of servo motor?
What happens to a motor if it is connected in Delta connection
Can we transmit digital signal to long distance ?
What does Bode plot tell you?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
