Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the 3ph capacitor is good or not.
- 14 Answers
- 59465 Views
- MacLellan, Yash Technologies, I also Faced
- E-Mail Answers
Answer Posted / andrew
Disconnect the capacitor from the supply and test the
capacitor terminals with a volt meter, you should have the
same voltage at these terminals as the supply voltage the
capacitor was connected to (you should probably not leave
it too long before you test the capacitor as some
capacitors tend to discharge b y themselves over time).
or you can discharge the capacitor by shorting the
terminals WITH A RESISTIVE LOAD you should never short out
a capacitor with that sort of voltage, it will be
danegerous, by using a resistive load, it will take longer
but it will be safer at least.
once you have discharged the capacitor, most decent
multimeters will have a capacitive test function, just test
the capacitor at the terminals and compare the value with
the value written on the side of the capacitpr and this
will also give you an indication of the its condition..
otherwise, call an electrician...
| Is This Answer Correct ? | 30 Yes | 5 No |
Post New Answer View All Answers
What is purpose of reactor?.What is different between line and bus reactor?
700KW 6.6KV slip ring induction motor to use VFD to control the speed
define the non synchoronism of synchoronous machine in general g or m??
What is the formula to calculate the rating of a three phase air circuit breaker
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
How the capacitance og capacitor volatage transformer is decided?
Define newton's law of viscosity.
whats the existence of reactive power and when it arises?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
how many Classification of fire extinguisher
Single line diagrams for star to delta and DOL starters.
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
what is the difference between 4pole & 6pole DC Motors & give advantage ?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
