Answer Posted / amit upadhyay dscl
T/F is a which device who convert the a.c voltage(high
potentional to low potential and low potentional to high
potentional) at the same frequency i.e.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Refernce currents are to be generated using refernce cueernts how can this be done
difference between the applicability of nortons and thevenin theorem
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
Which type of DG need Netral Earthing?
neutral earth resistance testing is it possible for transformer while in load condition
what is the thumb rule for determination resistance of resistor?
pre arcing time of ehv breaker
what is per unit calculation?looking for simple and strong explanation thk u
difference between semiconductor & conductor & insulator?
how did the testing of protection relays done through current injection
how to check regenerative load in drived motor
how calculate the electrical load for industry and office
