Answer Posted / leturtle
It is normal practice to have a rating for the earthing
system commensurate with the maximum system design fault
level. The normal maximum 400kV fault level is 63kA 1s.
Take the formula from EA TS 41-24 [6]
If you can't find it go to www.ees-group.co.uk on the FAQ
section.
Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
For a stable system, where should the poles of a system be in a root loci plot?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
Explain thin film resistors and wire-wound resistors
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Brief me about maintenance planning & sheduling of machine tool.
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
explain the types of drives
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?