What is the effect of leading power factor for power
transformer & D.G?
- 7 Answers
- 22099 Views
- Exide, I also Faced
- E-Mail Answers
Answer Posted / guest
Leading power factor causes the the current to reduce,due to
which the generator gets overloaded at its full load capacity.
| Is This Answer Correct ? | 5 Yes | 34 No |
Post New Answer View All Answers
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
Explain the advantages and disadvantages of thermal power plant?
What type of a DC motor would you use for a lift?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
how maney type tempereture measurement ?
How PADO software increase the efficiency of power plant?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
What is transmittance?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
What is the dependency of stiffness on load angle??
description about dry type transformers
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
