Interested to Buy Any Domain ? << Click Here >> for more details...
what we happen if 400 kvar cpacitor banks are on in manual
mode and there is no load on mains ??????????????
- 7 Answers
- 11096 Views
- HCL, Reliance, I also Faced
- E-Mail Answers
Answer Posted / chandra
The load power factor becomes leading and load becomes
source and power is supplying to the system instead of
receiving.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
how to calculate the change over time for star delta starter for different KW motor?
What the main causes of transient interruptions on Over-Head Distribution Lines?
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
What is installed in PAC that is control the humidity
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
volts=230 c=10mf a=??
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
