Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / santosh kumar jha
BDV means break down voltage.
This is the test of di-electric strength of transformer oil.
The sample is taken in electrolysis pot and applied a
voltage diff between anode and cathode of the pot , the
diff between the two plate is 2.5 mm.At first we appling
the voltage diff gradually , the voltage near which the oil
looses its insulation property, that voltage is called BDV.
| Is This Answer Correct ? | 157 Yes | 7 No |
Post New Answer View All Answers
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
which type of stability limit is higher,steady state or transient? why?
List the power rating of any 5 important electrical appliances used in houses.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
a governer in an Ic engine controls the
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
DG cranking voltage?
Why negative feedback is preferred in the control system?
what is v/f control in VFD?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
HOW WORK HEAT PLATE EXCHANGER
wat is d diffr btw shunt coil and trip coil in VCB?
what is frequency response?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
