Answer Posted / nagaraj.m
this is fully interlock system so this is not working in eb
power dg is not starting
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
explain safety measures in alternator?
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
Explain how you decide what size of electrical wire do you need?
What is the abbreviation of NGT panel
how 650 volts creates? where is use?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
I am going to appear RRB Sr. Section Engineer Exam, Electrical. Can you send me previous year questions of RRB Electrical engineer. specially Section Engineer questions. my email id is likerahulworld@gmail.com
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
What are the weight of 800KV DA,DB and DC type tower ?
oil cooled transformer
.php|
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
