Interested to Buy Any Domain ? << Click Here >> for more details...
which starter is used for synchronous motor
- 18 Answers
- 26192 Views
- APTransco, IBM, I also Faced
- E-Mail Answers
Answer Posted / kesavulu
Generally Synchronous motors are not self starting motors.
A pony motor is required to rotate and D.C extitation is
also required.Liquified rotary starters are used
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
What is creepage distance..... what will be the value for different voltage level
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
How capacitor improves pf
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
what is inverter and converter
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
Explain what is electric traction? Explain few advantages of electric traction system?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
How much load can take a 16 mm aluminum cable 3 phase
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
