What do you mean by creepage distance?
- 4 Answers
- 16706 Views
- Amara Raja, I also Faced
- E-Mail Answers
Answer Posted / anand gaikwad
In technical design of electrical equipments like CT, PT,
Circuit Breakers etc. the height of support insulator used
in it, to give enough ground clearance is of most
importance. However, this height is not absolute vertical
but it is measured following the curves of the insulator
with the help of cello-tape.
| Is This Answer Correct ? | 14 Yes | 9 No |
Post New Answer View All Answers
Differenciate between circuit wiring and sub main wiring with illustrations
How to decide cable tray size?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
how ct burden,magnetising current,ratio and knee point voltage are related & derived
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
How many types of electrical earthing are there?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
Explain RLC circuit?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
what do u understand from filter factor of reactor?
What is the basic principle of operation of alternators/dc generators?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
where we use the SFU & FSU?
what is value of Jin transformer
