Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
- 15 Answers
- 44356 Views
- ABC, Kirloskar, Sify, I also Faced
- E-Mail Answers
Answer Posted / suresh kumar
the answer of Mr. RVG is correct. But I would like to
correct the question itself. Distribution transformer
converts voltage from 33KV to 400V, not 400V to 33KV.
| Is This Answer Correct ? | 68 Yes | 11 No |
Post New Answer View All Answers
Whether power factor should be high or low? Why?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
What are the types of transformers according to the arrangement of iron cores?
How to calculate MCB Breaking capacity.
Why star delta starter is preferred with induction motor?
is that any software calculator to calculate the size of cable
High speed earth switch operation with diagram
What are the difference between normal application Transformer and Solar application Transformer?
How much dc volt applied in cathodic protection system?
what is buffer resistance starter.?.What is the working principle and where it is used..?
how to calculate the fault in substation
Define stepper motor. What is the use of stepper motor?
