Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / suresh kumar
Anti pumping relay is used to prevent closing coil from
being burnt by the repeated closing command. Closing coil
is not designed for continuous electrical operation and
once the closing coil is energised, breaker will get on and
it will be remain energised mechanically until any trip
command is available. So continuous supply is not required
for closing coil.
| Is This Answer Correct ? | 33 Yes | 8 No |
Post New Answer View All Answers
How a band pass filter is constructed?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
how to find Harmonics and types as per the equipemnts
How RTCC panel is working and give single line diagram for RTCC with transformer?
Formulae for calculating the transmission line losses for different voltage levels
clarify types of motor operated valves and advantages
what material is the electrical housing wire made of? is there any difference for the telephone lines?
design a 3 bit synchronous and asynchronous counter using T- flipflop
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
how can i get an electrical c-certificate?
is oil viscosity affect on motor current?
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
