Interested to Buy Any Domain ? << Click Here >> for more details...
I am an electrical power engineer and arranged power system
for a data center, I installed MCB, ELCB and erthing system
TN-C-S.
But some times several ELCBs Disconnect circuits at the
same time! what may be the reason? (the ELCBs are 25A ,30mA)
- 9 Answers
- 13139 Views
- I also Faced
- E-Mail Answers
Answer Posted / nageshwaran.n
Hi boss, check the connections properly.
Check for:
1. Total Load on MCB's. It should not exceed the market
rating.
2. For ELCB's, check the circuit for the leads interchange.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
State the types of distortions in amplifier?
what is the working principle of energy saver control panel. please give the complete calculation & theory.
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
how to calculate mf when meter and cTPT detail are given
Give some example of fault limiting devices?
why lightning arrestor are made in two stack of insulator but why not cvt
how to identify vector group of three phase transformer by voltage method?
what is sevice settings for mccb?How can be it setted?
What are the advantages and disadvantages of the ac motors?
How does zener phenomenon differ from avalanche breakdown?
What is the necessary and sufficient condition for stability.
