Interested to Buy Any Domain ? << Click Here >> for more details...
1. Why a DC motor starter is called 3 point starter
- 21 Answers
- 81508 Views
- ABB, CG, College School Exams Tests, Crompton Greaves, Infosys, Siva, I also Faced
- E-Mail Answers
Answer Posted / siddarth.m
the main purpose of using a three point starter is
to limit the starting armature current.......
This is because dc motor the initial voltage difference is
less so high current passes through the armature windings
which is not a desired factor.When we use a 3 point starter
it slowly induces the back emf in motor so that the voltage
difference is less and rate of current flow is less, so the
motor doesnt get spoiled
| Is This Answer Correct ? | 88 Yes | 24 No |
Post New Answer View All Answers
Ratings of power transformer,Distribution transformer.
Difference of induction motor & servo motor ??
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
What is the operating principle of turbo-generator.
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
How REF protects transformer alone? explain with diagram.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
what is cathodic protection and why it use in industries?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
sir pls send the je exam - 2008 and other model question papers..
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
