Answer Posted / mail2noor.hyd

T/C is working/?

1 check the thermocouples physical status, it is physically ok.
2 check the leads(terminals) ok
3 measure the room temp. in mv with the help of DMM
4 t/c kept in heat compared result mv vs temp.

can any send me a forbes marshall dtron 316 manual

1957

---

what are procedure of sox-nox calibration

2977

---

i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....

1474

---

What is the purpose of bypass valve across AS valve.

2110

---

Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .

1708

---

How to interfacing microcontroller with a DC motor

2064

---

Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd

2117

---

what is the imbustion control loop

1891

---

What is offset in a control system.

9021

---

which type of signal used in instrument?

9861

---

What are different type of instrument cable

2281

---

1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?

2214

---

What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?

2046

---

How to Calibrate Level Troll in field

1408

---

how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line

2114

---