Do you know how to joint the H.T and L.T Cables?
- 23 Answers
- 57441 Views
- KESC, MGVCL, Nokia, Oil Country Tubular, Power Control, SAGT, Siemens, Simco, Vivek Engineers, I also Faced
- E-Mail Answers
Answer Posted / jeorge f. nalugon
Theoritically, you can joint HV & LV cable by using BUTT
Connector then mechanically crimp them and insulate, but for
practical application it is not possible because at High
Voltage Level, LV cable insulation will fail...
| Is This Answer Correct ? | 2 Yes | 13 No |
Post New Answer View All Answers
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
Define cut-off rate?
Why do power lines not short out when they fall into water?
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
after how many spot we must chang secondry cable in portable spot welding gun?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
Draw the single line diagram of the power station?
Which material is used for the core of a transformer and why?
how can maintaince the acb contactor moveing and fixing kit
How to convert a two phase power into a three phase power in induction machine?
Define transfer function?
how to select energy meter? have any calculation?
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
