Suppose am having the PF value .8, so how can we say that
is it lagging or leading?
Answer Posted / chandrashekar g
POWER FACTOR
1.If the value is -0.8 then it is lagging pf.
2.If the value is +0.8 then it is leading pf.
| Is This Answer Correct ? | 13 Yes | 6 No |
Post New Answer View All Answers
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
What are the types of feedback oscillators?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
How to calculate fault level of 11 KV system
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
why booster transformer is used in sumpners test conducted on transformer????
placement paper samples of mspl company
What are the properties of a resistor?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Atwhat condition reverse power relay will act?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
STATE WORKING OF VACCUM CIRCUIT BRAKER?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
explain working principle of earth leakage relay