Answer Posted / yasar

to test hipot with vlf the applied voltage must be as follows
33/1.732=19.0,this is the individual RMS phase to ground
voltage of one phase,this voltage must be multiplied three
times for three phases which gives you 57.1KV.

if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value

1993

---

how current is reverse from its normal direction during the fault?

2515

---

Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me

1911

---

PLEASE ANYBODY HAVE ELECTRICAL CIRCUIT DIAGRAM FOR CHMER PULSE CD 60M SPARKING MACHINE.PLEASE MAIL ME SUPRIYAAYYAPPAN@YAHOO.CO.IN.

2859

---

How much dc volt applied in cathodic protection system?

2402

---

We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?

2239

---

Which motor connection is preferable star-delta or delta-star?

1123

---

What was your role in the silicon evaluation/product ramp? What tools did you use?

2002

---

2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping

1981

---

if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.

2033

---

What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer

1951

---

explain single phase series motor

1994

---

Y phase plates are used in transmission line??? what is there need???

2971

---

Explain how to determine capacitor tolerance codes?

1265

---

During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative

2165

---