Interested to Buy Any Domain ? << Click Here >> for more details...
what is bus pt and what is the function of it ???
- 8 Answers
- 31005 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / kanupriya
It is used in transmission lines to avoid the complete
shutdown, we sectionalise the main bus by providing single
phase PT for synchronisation in case the transmission lines
has more than 8bays
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
What is FM200 Gas??Applications........
why and how voltage sharing in transformer, during magnetic balance test ?
How can we checked Killo Watts of Motor & Alternator?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
difference between servo motor and synchronous motor
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
Details about Flux Compensated magnetic Amplifer starter for motors
why d.c produces corrosion
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
how to calculate cable size in diffrent loads?
what is positive , negative & zero equivalent system resistance
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
