Answer Posted / naveen kumar
if the DG is in auto mode
1)Signal may be not reaching the DG from main panel.
2)Battery may not have enough charge to crank the DG.
3)Shortage of fule in DG or flow of fule to th DG may have
problem.
4)In case of more no of DG controle wiring may have problem.
5)synchronization off DG may have problem.
6)phase sequence may have problem.
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
What was your role in the silicon evaluation/product ramp? What tools did you use?
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
Can we put 3 layers of cable tray while installing tray
why and how voltage sharing in transformer, during magnetic balance test ?
What are the relays in ACB and VCB
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Why we use mho Relay in long transmission line?
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is transformor oil gread
