Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / eswar
we are using 4 ma instead of 0 ma because the in order to
differentiate 0 input and fault condition(open circuit cable
or transmitter).
we are using maximum of 20ma because current above range can
cause fire or spark from short circuit conditions due to
weak installations.
| Is This Answer Correct ? | 56 Yes | 8 No |
Post New Answer View All Answers
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
How to check vortex flow meter is in good condition while we do not having calibration setup?
how to convert cubic metre per hour to newton cubic metre per hour
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
Q- What are the application in which PNP transistor is preferred over NPN ?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
kindly sent some demo question and answer
can you provide me full detail about instrumentation in ONGC??
what is instrument philosophy
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
Please asked me How calculate DCS controller memory.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
