Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER?
WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN
TRANSFORMER?
- 5 Answers
- 26025 Views
- ABB, Nissi Engineering Solution, NSL Sugars, I also Faced
- E-Mail Answers
Answer Posted / poonam
Vector Groups are made especially to make out difference in
the connections. The connection can be delta(D) or star(Y)
The number after that indicates the phase difference
between the primary and the secondary voltage.
e.g.-> Y11 means transformer is star connected with
secondary voltage leading the primary voltage by 30 degrees.
I am not sure of the effect of phase displacement in
transformer
| Is This Answer Correct ? | 16 Yes | 12 No |
Post New Answer View All Answers
how current is reverse from its normal direction during the fault?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
how to find three phase complex power in per unit and MVA?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
what is excitation/
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
HOW MANY TYPES OF FUSE?
Define active and passive network?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
Give some example of fault limiting devices?
how can you calculate fault level ?
