Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT ARE THE FACTORS REQUIRED FOR SELECTION OF TRANSFORMER
RATING?
- 13 Answers
- 29637 Views
- Tech Mahindra, Technip, I also Faced
- E-Mail Answers
Answer Posted / r.muthukumar
1) Amps
2) Volts
3) Phase angle
| Is This Answer Correct ? | 4 Yes | 12 No |
Post New Answer View All Answers
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Under wat condition statcom operates as an inductor for the transmission line?
What is the difference between earthing,ground&nutral?
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
3ph motor running with unequal kw and different pf what are the reasons
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
how much GROUND & NEUTRAL VOLT maintain in data center.
Earth leakage relay basic knowledge principle
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
Is there any abbrevation for STUB in Stub bus protection
How grounding is different than earthings?
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
he compression ratio for a petrol engine generally lies between
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
