Interested to Buy Any Domain ? << Click Here >> for more details...
Why is it that variation allowed in supply voltage to
motors is (+ or -)10 %, whereas that in frequency is (+ or -
)5 %
- 3 Answers
- 6725 Views
- I also Faced
- E-Mail Answers
Answer Posted / shriram.....
For the motor we are not using ups power supply
In ups power supply, we can maintain the voltage as well as
frequency.
But we are using raw power for motors in plants.
Eg if I we are using some load. Now I getting 415 volts at
full load if I reduce some load any reasons then voltage
will lightly increase so voltage will not stay constant.
For that reasons operating voltage +/- 10 %
Shriram....
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
how to flameproof electrical motor on the shaft?
show the single line diagram of star delta starter with single phase preventer
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
in non technical way how can u define POWER FACTOR??
How much ph is maintained of water resistance starter for slipring induction motor ?
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
How to see the inductance in a transmission lines
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
