Interested to Buy Any Domain ? << Click Here >> for more details...
why we do 2 types of earthing on tranformer ie:body earthing
& nutral earthing , what is function.
i am going to instal a 5oo kva tranformer & 380 kva DG set
what should the earthing value
- 8 Answers
- 32817 Views
- Altrion Technologies, I also Faced
- E-Mail Answers
Answer Posted / jayesh patel
Body earthing is used for body leakage current to earth &
not humen body harmful. Neutral earthing is used for
unbalance current pass through neutral & its goes to earth
& not effect on other phases voltages/load.
| Is This Answer Correct ? | 82 Yes | 4 No |
Post New Answer View All Answers
What is trip and closing coil in cb? Why need of them
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
What is phase cross over frequency?
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Why single phase induction motors are not self starting ?
How can you sized or estimate the ligthning arrester current rating?
lamination figures
i want to know that what is the eligibility critaria for ongc exam?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
why do we lay up the core of a cable?
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
