Answer Posted / sekhar_anama
CVT means capacitive voltage transformer which is connected
between the lightening arrester and CT,which is used to
measure the voltage in the line in higher ratings,PT is
connected at the end of the bus bar system which is also
used to measure the voltage.
| Is This Answer Correct ? | 23 Yes | 37 No |
Post New Answer View All Answers
What are the types of class b amplifier?
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
can the measured percentage error during calibration of single phase energy meter be negative?
132/66kv sub-station procation ?
what is earthing.how we make it,describe briefly.
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
why to use freewheeling diode ( diode in revers bias mode) across dc coil
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
What is the purpose of stablization resistor in high impedance bus bar protection
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
