Answer Posted / er. ankush miglani 9718151073
IT IS USED WITH GENERATORS FOR CHARGING A NO OF CAPACITORS
IN PARALLEL AND THEN DISCHARGING THEM IN SERIES.
INTRODUCED BY: E. MARX IN 1924.
IT IS USED WHEN VOLT. REQD FOR TESTING IS HIGHER THAN THE
AVAILABLE.
BUT CANNOT USE ABOVE 200KV THE SYSTEM BECOMES BULKY AND
EXPENSIVE.
FOR DAIGRAMS PLZ SEND ME UR EMAIL ID AT
ankushmiglani2000@gmail.com
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
how much LT load can bear by the 100 KW HT connection.
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
Can a generator runs after getting 1st stator earth fault.
can we synchronize star system generators with delta system transmission line ? and how ?
along with technical test papers
Mention the disadvantages of low power factor?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Name the test signals used in control system
define reflection method?
EXPLAIN THE ESSENTIAL FACTORS WHICH INFLUENCES THE CHOICE OF SITE FOR A HYDRO ELECTRIC POWER PLANT
What is the efficiency during maximum power transfer?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
What type of DC motor would you see for a lift?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
