Interested to Buy Any Domain ? << Click Here >> for more details...
Is it possible to get earth resistance value"zero" Ohm
practically???
If yes,which type of earthing???
- 9 Answers
- 16651 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / rafiq
yes its possible to get earth resistance zero ohm
by using copper earthing (copper plate )
| Is This Answer Correct ? | 4 Yes | 18 No |
Post New Answer View All Answers
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
what will happen if i connect 12 volt battery with 24 volt battery charger.
what is metering cum synchronizing panel and how it is used?
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
How to select the proper VSD to operate high inertial load
which pump used in STP
why -48 volts dc used in telecommucation
can anyone send me some sample question regarding power grid corp
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
describe the A.C. Generator Testing procedure
where lt & ht capacitor used
how can motor both beasrings insulation resistance can be check?
What are the factors influence the choice of an electrc drive?
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
